| |
Heater Series ”Š Designed For Liquor Distilling |
| |
|
|
| |
 |
|
| 1. |
Micom chip sensor the temperature to control the alarm. |
|
|
 |
|
| 2. |
Control the heating with just One button, very convenient. |
|
| |
 |
|
| 3. |
Better thermal transmission by filled with isolated thermal powder. |
|
|
 |
|
| 4. |
Fully submersible and excellent water-proof. |
|
| |
| 1. |
|
Put the heater to submerse completely while heating, the max depth is 120cm ”£1.2m”¤.
Plug in the power cord using a drip loop to prevent water from traveling along the cord and coming into contact with the receptacle. |
 |
|
Light is on”G
Heating |
 |
|
Light is off”G
Stop heating |
| ”“ |
|
Temperature range”G
45¢J”ć55¢J |
| ”“ |
|
Tolerance”G”Ó1¢J |
| ”“ |
|
Working temperature”G
5¢J”ć40¢J |
|
|
| 2. |
|
After plugging in, the LED screen will show the desired temperature of 50¢J, later it will change to the liquid temperature after twinkling 8 times. |
|
|
| 3. |
|
Set the desired temperature by pressing the button  one time to increase 1¢J ”£45¢J~55¢J make a cycle”¤. |
 |
|
| 4. |
|
While setting the temperature, the LED screen will twinkle 8 times the set number then return to the real liquid temperature. |
|
|
| 5. |
|
Red light turns on”GWhen the liquid temperature do not reach the desired temperature, the heater is heating. |
|
|
| 6. |
|
Red light turns off”GWhen the liquid temperature reaches the desired temperature, the heater cut off the power supply. |
|
|
| 7. |
|
If the liquid temperature is over 60¢J, it will generate the alarm and stop heating. |
|
|
| 8. |
|
If the liquid temperature is below 19¢J, the LED twinkles and keep heating. |
|
|
| 9. |
|
Abnormal liquid temperature”Gthe LED screen shows  ,while it is over 60¢J ,and shows  ,while it is below 5¢J; both will generate the alarm and stop heating. |
|
|
| |
| 1. |
|
Please avoid hitting the heater against the tank wall. |
 |
|
| 2. |
|
Please locate the heater submerse completely. |
 |
|
| 3. |
|
The main body mustn't drop into the liquid or get wet, to prevent short-circuit or electric shock. |
|
|
| 4. |
|
The heater is not intended for use by young children or infirm persons without supervision. |
|
|
| |
- The power supply wire cann't be replaced ,if it is damaged the appliance must be scrapped.
- it is needed to at times eliminate the contamination oxide happened to the plug.
- it is needed to timely eliminate the foreign matters ”£calcium substance ,limescale”¤ on the heating glass.to be eliminated.
|
| |
”°Warning”G |
Make sure to unplug the power source or cut off the power source before proceeding the repair and maintenance. |
| |
Please cut off the power source and unplug the electric wire
for safety, if any situations of danger or urgency happened. |
- Under normal use and service, all appliances carry 12 months warranty from the date of purchase on parts and labor against manufacturing defects. Please return the unit if deemed defective to your local dealer for repair or replacement.
- The warranty is limited to this appliance only, Not responsible for consequential loss or damage.
|
|
|
CS061A-100 DIRECTIONS Download 
