Index  >> Aquarium Products  >> Heater Series  >> CS061  
 
 
        ”DCS061 Series
        ”DCS061A Series
        ”DCS064A Series
        ”DCS065 Series
     Heater Series
 
    CS061 Series     Micom Heater    
 
 
 
 
 
 
 
 
 
 
 
  Features
 
   
1. Micom chip alarms at high temp. Flashes at low temp.
   
2. Dial easily, very convenient.

   
3. Better thermal transmission by filled with isolated thermal powder.
   
4. Fully submersible and excellent water-proof.

   
5. Plastic heater guard protects fish against scald.
 
  Instruction for use
 
 
1.   Fully submerse heater and fix to the glass with supplied suction cups, by using the hook and suction cups to fix the main body to the glass before plugging in power source.
  Light is on”G
Heating.
  Light is off”G
Stop heating
”“   Temperature range”G
20¢J”ć34¢J”C
”“   Tolerance”G”Ó1¢J”C
 
2.   Must put the heater submerse completely while heating, the max depth limit is 120cm”£1.2m”¤.  
 
3.   While plugging in power or power failure than back. The LED indicator will show the previous temperature. After flashes 8 times it will turn to the real water temperature.  
 
4.   Set the desired temperature by pressing the button , press one time to increase 1¢J”£20¢J~34¢J make a cycle”¤.
 
5.   While setting the temperature, the LED will twinkle 8 times the set number then return to the real water temperature.  
 
6.   Red light turns on”GWhen water temperature do not reach the desired temperature, the heater is heating.
 
7.   Red light turns off”GWhen water temperature reaches the desired temperature, the heater cut off the power source.
 
8.   If the water temperature is over 35¢J, it will generate the alarm and stop heating.  
 
9.   If the water temperature is below 19¢J, the LED twinkles and keep heating.  
 
10.   Abnormal water temperature”Gthe LED shows ,while it is over 38¢J, and shows ,while it is below 10¢J; both will generate the alarm and stop heating.  
 
11.   Correcting the temperature”Gpress the button ,over 4 seconds, the LED will twinkle the two numbers of decimal point, to adjust the temperature by using the screw driver”£flat type”¤to insert the correcting hole on the back of the main body.
   
Attention: During the abnormal situation this function is unable to flashes caution.
 
 
12.   The LED returns to normal display by pressing the button one time while it is the number of decimal point.  
 
 
13.   Abnormal press the button more than 8 seconds. The LED indicator will flash Er (Error) to caution and stop heating.  
 
 
  Reference for choosing Heater
 
  ”µt¢X 
Liters 70 140 200 300 400
5¢J 100 200 200 300 400
10¢J 100 200 300 2X300 2X400
15¢J 200 2X200 2X300 2x400 3x400
 WATTS
  ”µt¢X”×Optimum aquarium temperature-Minimum
       room temperature
”“Above listed data just for reference
 
  Important notes
 
 
1.   While feeding the noble fish, please add to use the Micom thermostat for dual protection.
 
2.   Please avoid hitting the heater and do not use the cracked heater.
 
3.   Fixed the heater horizontally to where has better circulation of water.
 
4.   Plug in the power cord using a drip loop to prevent water from traveling along the cord and coming into contact with the receptacle.
 
5.   Control body do not fall into the water or get wet to prevent short circuit or electric shock.  
 
6.   Young children or infirm persons without supervision do not intend the heater for use.  
 
 
  Repair & Maintenance
 
 
  • The electric wire can't be replaced, if electric wire has damaged this heater must be scrapped.
  • The plug need to be regularly clean up the contamination oxide happened.
  • The foreign matters ”£calcium substance, limescale”¤ on the glass need to be eliminated.
  ”°Method as below”G
 
  • Prepare 20l water and 200g citric acid.
  • Put heater in the tank then add citric acid in the water.
  • Set the temperature for 34¢J.
  • Counting the time for 12 hours then check heater again.
  ”°Warning”G Make sure to unplug the power source or cut off the power source before proceeding the repair and maintenance.
 
  Emergency Handing
 
  Please cut off the power source and unplug the electric wire for safety, if any situations of danger or urgency happened.
 
  Limited Warranty
 
  • Under normal use and service, all appliances carry 12 months warranty from the date of purchase on parts and labor against manufacturing defects. Please return the unit if deemed defective to your local dealer for repair or replacement.
  • The warranty is limited to this appliance only, Not responsible for consequential loss or damage.
 

 
  CS061 DIRECTIONS Download
CS061 DM Download