|
|
|
|
Model NO. |
CS061A Series |
Size
”£mm”¤ |
Controller
Width”G50
Height”G80
Deep”G34
Heater
OD”G33.5
L”G400W”G220
200W”G270
200W”G220
100W”G150 |
|
|
|
|
|
|
1. |
Micom chip alarms at high temp. Flashes at low temp. |
|
|
|
|
2. |
Dial easily, very convenient. |
|
|
|
|
3. |
Better thermal transmission by filled with isolated thermal powder. |
|
|
|
|
4. |
Fully submersible and excellent water-proof. |
|
|
|
|
5. |
Plastic heater guard
protects fish against scald. |
|
|
1. |
|
Fully submerse heater and fix to the glass with supplied suction cups, by using the hook and suction cups to fix the main body to the glass before plugging in power source. |
|
|
Light is on”G
Heating. |
|
|
Light is off”G
Stop heating |
”“ |
|
Temperature range”G
20¢J”ć34¢J”C |
”“ |
|
Tolerance”G”Ó1¢J”C |
|
|
2. |
|
Must put the heater submerse completely while heating, the max depth limit is 120cm”£1.2m”¤. |
|
|
3. |
|
While plugging in power or power failure than back. The LED indicator will show the previous temperature. After flashes 8 times it will turn to the real water temperature. |
|
|
4. |
|
Set the desired temperature by pressing the button , press one time to increase 1¢J”£20¢J~34¢J make a cycle”¤. |
|
|
5. |
|
While setting the temperature, the LED will twinkle 8 times the set number then return to the real water temperature. |
|
|
6. |
|
Red light turns on”GWhen water temperature do not reach the desired temperature, the heater is heating. |
|
|
7. |
|
Red light turns off”GWhen water temperature reaches the desired temperature, the heater cut off the power source. |
|
|
8. |
|
If the water temperature is over 35¢J, it will generate the alarm and stop heating. |
|
|
9. |
|
If the water temperature is below 19¢J, the LED twinkles and keep heating. |
|
|
10. |
|
Abnormal water temperature”Gthe LED shows ,while it is over 38¢J, and shows ,while it is below 10¢J; both will generate the alarm and stop heating. |
|
|
11. |
|
Correcting the temperature”Gpress the button ,over 4 seconds, the LED will twinkle the two numbers of decimal point, to adjust the temperature by using the screw driver”£flat type”¤to insert the correcting hole on the back of the main body.
|
|
|
|
Attention: |
During the abnormal situation this function is unable to flashes caution. |
|
|
12. |
|
The LED returns to normal display by pressing the button one time while it is the number of decimal point. |
|
|
|
|
13. |
|
Abnormal press the button more than 8 seconds. The LED indicator will flash Er (Error) to caution and stop heating. |
|
|
Reference for choosing Heater |
|
|
”µt¢X |
Liters |
70 |
140 |
200 |
300 |
400 |
5¢J |
100 |
200 |
200 |
300 |
400 |
10¢J |
100 |
200 |
300 |
2X300 |
2X400 |
15¢J |
200 |
2X200 |
2X300 |
2x400 |
3x400 |
|
WATTS |
|
”µt¢X”×Optimum aquarium temperature-Minimum
room
temperature
”“Above listed data just for reference |
|
1. |
|
While feeding the noble fish, please add to use the Micom thermostat for dual protection. |
|
|
2. |
|
Please avoid hitting the heater
and do not use the cracked heater. |
|
|
3. |
|
Fixed the heater horizontally to where has better
circulation of water. |
|
|
4. |
|
Plug in the power cord using a
drip loop to prevent water from
traveling along the cord and
coming into contact with the
receptacle. |
|
|
5. |
|
Control body do not fall into the water or get wet
to prevent short circuit or electric shock. |
|
|
6. |
|
Young children or infirm persons without supervision do not intend the heater for use. |
|
|
|
- The electric wire can't be replaced, if electric wire has damaged this heater must be scrapped.
- The plug need to be regularly clean up the contamination oxide happened.
- The foreign matters ”£calcium substance, limescale”¤ on the glass need to be eliminated.
|
|
- Prepare 20l water and 200g citric acid.
- Put heater in the tank then add citric acid in the water.
- Set the temperature for 34¢J.
- Counting the time for 12 hours then check heater again.
|
|
|
”°Warning”G |
Make sure to unplug the power source or cut off the power source before proceeding the repair and maintenance. |
|
Please cut off the power source and unplug the electric wire
for safety, if any situations of danger or urgency happened. |
- Under normal use and service, all appliances carry 12 months warranty from the date of purchase on parts and labor against manufacturing defects. Please return the unit if deemed defective to your local dealer for repair or replacement.
- The warranty is limited to this appliance only, Not responsible for consequential loss or damage.
|
|